/* net100: ring-3 command. Force 100BASE-TX or restore auto/1G. * * This is the diagnostic fallback for a marginal 1000M pair/jack: 100BASE-TX * uses only two pairs, so a link that reports 1000M but loses DHCP/ARP * broadcasts can still be fully usable. The driver keeps the setting until * `net100 off` or reboot. */ #include "ucmd_lib.h" static int arg_is(const char *arg, const char *word) { unsigned int i = 0; while (arg[i] && word[i] && arg[i] == word[i]) i++; return arg[i] == '\0' && word[i] == '\0'; } static void usage(void) { u_puts("net100: usage net100 [on|off] (on = force 100M, off = auto/1G)\n"); } void _start(const char *arg) { struct sys_netinfo n; unsigned int mbps; int r; if (!arg || !arg[0] || arg_is(arg, "on") || arg_is(arg, "100")) mbps = 100; else if (arg_is(arg, "off") || arg_is(arg, "auto") || arg_is(arg, "1000")) mbps = 0; else { usage(); u_exit(1); } if (u_syscall1(SYS_NET_INFO, (int)&n) != 1) { u_puts("net100: no NIC found\n"); u_exit(1); } r = u_syscall1(SYS_NET_SPEED, (int)mbps); if (r == -1) { u_puts("net100: speed control not supported by "); u_puts(n.name); u_putc('\n'); u_exit(1); } if (r == -2) { u_puts("net100: NIC is busy (see ps)\n"); u_exit(1); } u_puts(mbps == 100 ? "net100: forcing 100M\n" : "net100: restoring auto/1G\n"); u_syscall0(SYS_NET_PRINT_INFO); if (r == -3) { u_puts("net100: link did not come up; check the cable/port\n"); u_exit(1); } if (r == -4) { u_puts("net100: link is up but not at 100M\n"); u_exit(1); } u_exit(0); }